Here’s the method I use to zero the iron sights on an AR-15 rifle.  The purpose of zeroing your sights is so that your point of aim equals your point of impact.  So here’s the method I use on the AR-15.  Feel free to ask any questions if any of this needs clarification 🙂

  1. Set your elevation knob to 8/3 low or if you are using the carry handle which is what I do, to 6/3 low.  The elevation knob will be located just below the peep sight.
  2. Flip the aperture to the long range sight (small peephole) although as you get older you may find the short range aperture (large peephole marked 0-2) easier to use and if that is the case then use the short range sight.
  3. From a steady position aim at the center bulls eye of your paper target, which should be set out at 25 meters which is equal to approximately 27.34 yards and fire a 6 round grouping.
  4. If your grouping has hit the bulls eye then there is no further adjustments needed.
  5. If the grouping has not hit the bulls eye then calculate how far away you are from the bulls eye both vertically and horizontally and adjust as follows.
  6. Calculate your clicks of windage (left to right) required to move the impact point towards the center of the bulls eye.  On an AR-15 using .223 ammunition at 27.34 yards, each click equals 3/8 of an inch.  Then adjust by rotating the windage knob located on the right side of the carry handle.
  7. Calculate clicks of front sight elevation (up and down) required to move the impact point towards the center of the bulls eye.  On an AR-15 at the previous referenced distance; elevation equals 3/8 of an inch for each click.
  8. Using a $7.00 or so front sight adjustment tool (much easier to use then a nail) depress the front sight plunger and turn the required number of clicks to move your point of impact towards the bulls eye.  Clockwise lowers the sight but raises the point of impact.  Counter clock wise raises the sight but lowers the point of impact.
  9. Fire another 6 rounds at the bulls eye.  If your grouping hits the bulls eye your adjustments are done.  If not, repeat steps 5 through 9 until your point of aim finally equals your point of impact.

Advertisements
Comments
  1. lofiegos says:

    Woww, thks for your article..It is so important to know how to zero your AR-15 scopes. Great share. Cheers!

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s